We're sorry, but OSHAcademy doesn't work properly without JavaScript enabled. Please turn on JavaScript or install a browser that supports Javascript.

619 Materials Handling Safety
Skip to main content

Care and Use of Slings

Proper care and use are essential for maximum service and safety. Slings must be protected with cover saddles, burlap padding, or wood blocking as well as from unsafe lifting procedures such as overloading to prevent sharp bends and cutting edges.

Worker attaching a load to a spread bar.
Make sure to check a sling attached to a spreader bar.

Follow these safe practices when working with slings:

  • Before making a lift, check to be certain that the sling is properly secured around the load and that the weight and balance of the load have been accurately determined.
  • If the load is on the ground, do not allow the load to drag along the ground. This could damage the sling. If the load is already resting on the sling, ensure that there is no sling damage prior to making the lift.
  • Next, position the hook directly over the load's center of gravity and seat the sling squarely within the hook bowl. This gives the operator maximum lifting efficiency without bending the hook or overstressing the sling.
  • Wire rope slings also are subject to damage resulting from contact with sharp edges of the loads being lifted. These edges can be blocked or padded to minimize damage to the sling.

After the sling is properly attached to the load, there are a number of good lifting techniques that are common to all slings.

  1. Make sure that the load is not lagged, clamped, or bolted to the floor.
  2. Guard against shock loading by taking up the slack in the sling slowly. Apply power cautiously to prevent jerking at the beginning of the lift, and slowly accelerate or decelerate.
  3. Check the tension on the sling. Raise the load a few inches, stop, and check for proper balance and that all items are clear of the path of travel. Never allow anyone to ride on the hood or load.
  4. Keep all personnel clear while the load is being raised, moved, or lowered. Crane or hoist operators should watch the load at all times when it is in motion.
  5. Obey the following "Nevers."
    • Never allow more than one person to control a lift or give signals to a crane or hoist operator except to warn of a hazardous situation.
    • Never raise the load more than necessary.
    • Never leave the load suspended in the air. And never work under a suspended load or allow anyone else to.

Once the lift has been completed, clean the sling, check it for damage, and store it in a clean, dry airy place. It is best to hang it on a rack or wall.

Remember, damaged slings cannot lift as much weight as new or older well-cared for slings. Proper and safe use and storage of slings will increase their service life.

Knowledge Check Choose the best answer for the question.

3-10. When lifting a load, where should the hook be positioned over the load to give maximum lifting efficiency?