We're sorry, but OSHAcademy doesn't work properly without JavaScript enabled. Please turn on JavaScript or install a browser that supports Javascript.

619 Materials Handling Safety
Skip to main content

Brake Test

The operator must test the brakes each time a load that is 90% or more of the maximum line pull. The test is handled by lifting the load a few inches and applying the brakes. In duty cycle and repetitive lifts where each lift is 90% or more of the maximum line pull, this requirement applies to the first lift but not to successive lifts.

Crane lifting large load to the top of a building
Cranes cannot travel with load if prohibited by manufacturer.

Protection Against Rope Detachment

To prevent rope from becoming detached from a drum, neither the load nor the boom must be lowered below the point where less than two full wraps of rope remain on their respective drums.

Traveling with a Load

Traveling with a load is prohibited if the practice is prohibited by the manufacturer. Where it is not prohibited, you must take precautions to prevent hazardous movement of the load and avoid excessive movement of the load that could overload the crane.

Authority to Stop Operation

OSHA regulation 1926.1418 provides that, whenever there is a concern about safety, the operator must have the authority to stop and refuse to handle loads until a qualified person has determined that safety has been assured.

Knowledge Check Choose the best answer for the question.

3-5. The operator must perform a brake test _____.